We pride ourselves on using the most advanced technology for designing automotive interior protection patterns. We strive to please our customers with clean lines and aesthetically pleasing material to enhance the look of the trim while protecting from scratches and damage to maintain the value of a vehicle through multiple owners.
Don't forget to tag us (@screenprotech) in your before/after pictures and installation videos!
For best installation environments, please have the vehicle cooled down, make sure screens are cool to the touch, and vehicle is parked out of direct sunlight. After installation, avoid letting the vehicle heat up for the first 24 hours. If it must be parked outside, crack windows to let excess heat out. After 24 hours, film should be mostly cured and any remaining haziness will diminish within a few days (That's when you can take the good pictures 😉)
Screens should be cool to the touch (70 degrees inside the cab)
Fill bottle with warm water
Spray surface, wipe surface
Spray surface, use squeegee to remove dust particles
Lift edge of film to be installed, spray edge, spray as you separate film from backing
Saturate back of film, more solution = easier to set properly & easier to squeegee
Adjust and align softly with fingertips
Use squeegee in center of film with small strokes to tack
Lightly mist top of film
Squeegee from center of film to right, switch hands (if possible), squeegee from center to left working up and then down the film
Wrap towel around squeegee, and then squeegee from center to edges (clockwise or counter clockwise) around all edges
Use towel to wipe excess moisture
REPEAT with additional film/trim
NOTE: If there is dust or excessive remaining bubbles, mist edge of film and GENTLY lift while spraying (to avoid breaking the adhesive) until film is lifted past dust/bubbles/etc. Respray, re lay down the film, re mist, then squeegee from inner-most lifted part outwards, using techniques above.
For Kits with buttons or small pieces, install everything else first, empty bottle, and fill with plain water for better tacking!
Moisture bubbles are normal to appear up to 2 days after installing and will disapate within 7 to 14 days. (Cold weather may extend cure time)
On large (Tesla style) touch-screens it is normal for the first 24 hours for the screen to act a little erratic as moisture bubbles feel like fingers. Use extra care when you squeegee out extra moisture to help minimize the touch-sensitivity.
For additional installation techniques or questions, feel free to reach out!
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.